High-End Additive For Dry Mortar & Concrete

HomeHigh-End Additive For Dry Mortar & Concrete


Denka CSA #20

Description

DENKA CSA#20 is made by calcium sulfo Aluminate which mainly consists of lime stone, gypsum and bauxite in an dequate distribution. DENKA CSA#20 reduces dry shrinkage crack as well as improve water tightness in cementitious hydrates.

Features

  • Minimize the cracking caused by drying shrinkage (Shrinkage compensation)
  • Chemicals Pre-stress
  • Increase water tightness

Application

  • Dry mix mortar to minimize cracking due to dry shrinkage
  • Pre-cast concrete member to improve bending toughness by chemical pre-stress with reinforced bar

Denka Power CSA Type-S

Description

DENKA POWER CSA is a high performance additive for the compensation and reduction of shrinkage for concrete and mortar.

Features

  • Shrinkage compensation
  • Increase water tightness
  • Good cost performance

Application

  • Dry mix mortar to minimize cracking due to dry shrinkage
  • Ready-mixed concrete to minimize cracking due to dry shrinkage and improve water tightness

Denka SC-1

Description

DENKA SC-1, special amorphous calcium aluminate based accelerator, introduces very fast setting time and very high early strength development in cement.

Features

  • Fast setting/Drying
  • High compressive strength at early age
  • High reactivity under low temperature
  • Low shrinkage
  • No potentiality of conversion

Application

  • Self leveling mortar
  • Pre-cast concrete
  • Nonshrink grout
  • Tile adhesive mortar
  • Repair/rendering mortar
  • Dry process shotcrete

Packing

20KG paper bag or 1MT big bag

Denka Beform

Description

DENKA BEFORM is a quick-hardening cement admixture that has been developed based with the special cementitious admixture technologies that DENKA has cultivated over the years.

Features

  • Packing: 25kg/bag
  • Appearance: Greyish white powder
  • Specific weight: 2.92
  • Blaine specific surface area: 6000cm2/g
  • Additive amount:

Application

  • Excellent in obtaining initial strength. 10 to 30MPa strength can be obtained in 6 hours
  • Excellent in crack resistance
  • Due to its expansion characteristics, self-shrinkage and drying shrinkage can be reduced
Back to Top